Product code: P01325
Non-insulated busbar crimp terminals for mini blade fuses. Can be used in any of the modules that hold mini blade fuses from the MTA modular fuse and relay system.
Busbar terminals consist of a row of individual terminals linked on a strip. A single cable connection to one terminal will provide common power to the entire strip, minimising the number of crimps that need to be made.
These should be used on the input (or battery) side of the fuses only and can be used in a strip of 10 (e.g. 2 strips of 10 in the module with 20 mini blade fuses) or cut down into smaller strips as required (e.g. 2 strips of 3 in the module with 4 micro relays and 6 mini blade fuses).
Terminals are crimped and/or soldered to the cable and then inserted into the slots in the underside of the module, with features on the terminals ensuring error-proof insertion. Yellow secondary locking bars on the module should then be pushed into place to prevent accidental terminal removal.
Sold as a strip of 10 connected terminals.
The following tools can be used to crimp this terminal:
P00454 or P00456
Part Number: FH307TR
!st class service, 1st class products, all delivered next day. Thankyou 12v Planet!!
First time I used the MTA system I didn't use busbar terminals and ended up trying to cram lots of wires into each terminal, which didn't go well. Definitely use these instead.My only qualm is that I dont know how much current the busbar strip is rated for and near where the single(?) power wire is connected, currents could be quite high. I'm not sure I'd like to see potentially 30A rushing through the strip? This is of course just a design issue and there is plenty of room on the strip to solder extra wires to carry high currents if needed.
I ordered from Japan, but it arrived within a week despite the low shipping cost.Thank you!
When I opened up my order everything looked right. Then when I went to actually install the parts I noticed someone had nicked the end off one of the busbars so that there was only 9 pins instead of ten. Kinda a little thing and not a big problem to solve but hey, kinda annoying someone threw this crappy cut up part into my order.
Please accept our apologies for this error. We must have accidentally cut a strip of 9 instead of 10 as these bsubar strips should be in 10s.Please get in touch and we will happily send you a replacement strip. Sorry again for the inconvenience.
Need some hints, tips or guidance on 12V electrics? Visit our Knowledge Centre for a wealth of useful information
Watch our YouTube "how to" guides here
Free UK Delivery on Orders over £100Standard Delivery only £3.95*Exclusions Apply
We accept telephone ordersCall 01844 885100
We Ship Worldwide
© 2021 12 Volt Planet Ltd. All Rights Reserved. Company Reg no. 8239412
Home > Fusing & Circuit Protection > MTA Modular Fuse & Relay Holding System > Terminals