Special terminal clamp for use with ceramic cube fuses with double connection points that fits the positive battery post. This fusing arrangement eliminates any unprotected section of the cable coming from the battery, giving you maximum protection for your circuits.

The fuses fit over the threaded studs on the clamp and the cable is then fitted using ring or copper tube terminals with a hole dia of 12mm and the supplied isolation nuts. The isolation nuts fit into the 12mm holes of the ring terminals and prevent the terminals making contact with the studs, ensuring all current flows via the fuses (if a terminal was to touch the stud it would by-pass the fuse and render it redundant).

To ensure effective isolation, we recommend only using a single ring terminal per post. 

This clamp fits SAE tapered positive battery posts only.

Note: fuses and ring terminals not included - fuses can be purchased separately here.

Further information

The maximum torque when tightening the isolation nut is 15Nm. Any greater can cause the nut to crack.

Note: Not to be used with Blue Sea Systems MRBF fuses.